Well I have WH older radius arms and one now has a significant crack thru the lower 1/4 to 1/3 of the arm where it comes into the "C" section toward the axle. I was warned to watch these and sure enough now they appear to be failing.
Anyone else had this problem? I have had good experience with WH in the past and am hoping they will replace or discount me on a new set. I will call tomarrow, just hoping they don't tell me "too bad".
On the fix it side - I dont see how re-welding the section would fix it. I am thinking I would need to plate both sides of the "C" section and down the arm at least 8" to ensure they do not fail again. My other alternative is to make all new arms but that will cost some $$$$.
FM
Anyone else had this problem? I have had good experience with WH in the past and am hoping they will replace or discount me on a new set. I will call tomarrow, just hoping they don't tell me "too bad".
On the fix it side - I dont see how re-welding the section would fix it. I am thinking I would need to plate both sides of the "C" section and down the arm at least 8" to ensure they do not fail again. My other alternative is to make all new arms but that will cost some $$$$.
FM
Comment