Re: FiTech no start
Why change the ignition at all? Keep the resistor wire (or ballast resistor if that's what you're using) for the Mallory and run 12v off of a separate circuit to all the computer stuff. You should be doing that anyway I would think, rather than using the same circuit to do all duties. Especially if this is all original Bronco wiring.
Is that how it's run, or do you have all new chassis wiring too?
What about the FiTech unit? Is it the 400 or the 600? If 600, is it controlling the ignition? I'm thinking not, since I don't think it's compatible with a Unilite, but I could be wrong on that point.
Good luck.
Paul
Why change the ignition at all? Keep the resistor wire (or ballast resistor if that's what you're using) for the Mallory and run 12v off of a separate circuit to all the computer stuff. You should be doing that anyway I would think, rather than using the same circuit to do all duties. Especially if this is all original Bronco wiring.
Is that how it's run, or do you have all new chassis wiring too?
What about the FiTech unit? Is it the 400 or the 600? If 600, is it controlling the ignition? I'm thinking not, since I don't think it's compatible with a Unilite, but I could be wrong on that point.
Good luck.
Paul
Comment