If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I going to a buddie to pull a wire harness and computer out of a 92 mustang tomorrow . I have never done this, so anything I should know or think about befor doing it?
Before you guys do that, I actually have a full engine harness, injector harness, and o2 sensor harness sitting in my garage. Everything is in pretty good condition, I was going to use it but decided to go with the RJM harness. Just make me an offer all its doing is taking up space and I need money.
Before you guys do that, I actually have a full engine harness, injector harness, and o2 sensor harness sitting in my garage. Everything is in pretty good condition, I was going to use it but decided to go with the RJM harness. Just make me an offer all its doing is taking up space and I need money.
Kyle
530-368-2259
Hey I appreciate your offer, but I am getting all of it for $50 . I bet you can get at least $150 for what you have.
Like I said I need some cash. I know I can get a lot more but if you can use it for your build give me 60 and its yours. Not to tell you what to do but I highly recommend going with the RJM harness. just save your pennies and get it. it will make your life so much easier.
I started my own harness too, after about 40 hours cutting soldering looming etc the wife ordered up a RJM harness. She was tired of all the cussing coming from the back room glad I went that way, but I also learned alot about the wiring/pin-out. Have fun!
68 Slightly modified
67 LUBR once again
61 Willy Wagon
Comment