Output shaft rebuild

[Broncrick]

Got it apart but dont have the tools to pull the final bearing, or put it back on either. Then shims, and end play are an issue also. Who in Sactown is decent? Edit, Dana 20

Chucks hardened one going in

Thanks, Rick-

[mtnbronco]

call foothill offroad in Auburn. If they don't do it they can recommend someone

[Daddy4zack]

try specialized 4x4..

[Broncrick]

Heck w/em all at $100+ (1 hr rate) min. I decided since this only has 400 mi on it, I'll just buy an inner bearing for $15 and do it myself. Couldnt find a shop with a press that would do it for a 12 of good beer even. Even a full bearing/gasket rebuild is only $120 from the houses. So I'll borrow a dial ind and I'll get this chit installed this weekend! Then I also have a trail spare w/the bearing on it too!

:rant off:

Rick-

[Delta 4 Wheel]

Remember to set up new bearings slightly tighter than used bearings because the new bearing will break in. I could tell you how to "feel" for the right preload...The right feel would feel like a nice smooth squishey turn of the shaft...well sort of.

[Broncrick]

Will do

[welndmn]

If you have not done it yet, I am only 1 hour from ya rick.

[Broncrick]

If you have not done it yet, I am only 1 hour from ya rick.

Thanks Mark, I'll keep ya in mind for next time. Heated the bearing, froze the shaft, tap, tap, done Got it all put back together, going in this weekend! miss the snow......

[welndmn]

Ahh, I am going 2/11