79 Big Bronco PS box question.

[madgyver]

I am not sure on these. I have a chance to grab one today but it's on the other side of the island.
Is the pitman arm facing forward?
Are the bolt mounting holes the same as the stock EB PS box mounting holes?
Looking to use it for a front stretch.
TIA

[Daddy4zack]

Re: 79 Big Bronco PS box question.

yes the arm faces forward. no the holes are not the exact same but close to the eb box..

[TRAILBOUND]

Re: 79 Big Bronco PS box question.

arm faces foward, check out bc broncos they sell a frame reinforcement kit for the 4x4 box. It comes with a piece of 3/8 plate with proper hole location, new bolts and frame sleaves ( the ones that go inside the frame for the bolts to pass through) all for like $35

[madgyver]

Re: 79 Big Bronco PS box question.

I'll fab something up if need to but first I need to grab this PS box up.

[Action]

Re: 79 Big Bronco PS box question.

Does that box mount outside the frame?
Jack

[crawlin68]

Re: 79 Big Bronco PS box question.

Does that box mount outside the frame?
Jack

Yes, outside.

[Broncrick]

Re: 79 Big Bronco PS box question.

Yes, outside.

...and plate the frame around it!

[crawlin68]

Re: 79 Big Bronco PS box question.

...and plate the frame around it!

I plated the inside and outside of my frame with 3/8 plate!!

[CityHick]

Re: 79 Big Bronco PS box question.

I plated the inside and outside of my frame with 3/8 plate!!

Mr. Overkill strikes again!

(however I plated the outside of my frame with 3/8" plate too )

[Daddy4zack]

Re: 79 Big Bronco PS box question.

Mr. Overkill strikes again!

(however I plated the outside of my frame with 3/8" plate too )

1/4 inside and out.. .. maybe i need more..

Aaron

[Delta 4 Wheel]

Re: 79 Big Bronco PS box question.

I plated the inside and outside of my frame with 3/8 plate!!

The entire frame? I knew it!!!

[madgyver]

Re: 79 Big Bronco PS box question.

Hey, any of you guys got pics of the mods?
I wanna see....

[FFMDX]

Re: 79 Big Bronco PS box question.

I used 3/8" plate, made a "C" the dropped over the top of the frame and then reinforced it a little. After doing my TRO, I had to move the box foward ~ 1.25" for clearance.

Sean