Anyone have any experience changing a distributor gear?
It was VERY difficult to get the original gear off using heat, a three jaw puller and a hammer.
My question (after seeing the difficulty of removal) is how am I supposed to get the new gear back onto the distributor shaft?
Are their any tricks, or should this be done by a shop with a press?
I'm also worried about lining up the holes for the roll pin.
Any help is appreciated.
Thanks,
Dylan
It was VERY difficult to get the original gear off using heat, a three jaw puller and a hammer.
My question (after seeing the difficulty of removal) is how am I supposed to get the new gear back onto the distributor shaft?
Are their any tricks, or should this be done by a shop with a press?
I'm also worried about lining up the holes for the roll pin.
Any help is appreciated.
Thanks,
Dylan
Comment